Finish Low sheen
Drying Time Touch Dry 30 minutes Recoat 2 hours at 25°C (Allow 4 hours in cold or humid areas.)
- UV RESISTANT
- WATER BASED
- LONG LASTING
Tips & Advice
Preparing the Surfaces
New Work Surfaces must be sound, clean, dry and free from grease, wax or any loose material that prevents good adhesion. Rub down using a suitable abrasive paper and dust off. For masonry surface, the relative humidity should be under 17% according to Protimeter or let the substrate dry from 21-28 days in normal conditions (average temperature 30°C, humidity of environment is about 80%) Previously Painted Surface Remove all loose and flaking paint by scraping or sanding previously painted areas and sand smooth. Surface must be free of any loose material that prevents good adhesion. If mould is present, treat with suitable fungicidal wash or diluted bleach and rinse with clean water. Allow to dry before painting. For Galvanised Steel Surface Degrease new galvanised steel and abrade structural galv to remove chemical treatments to ensure maximum adhesion.
Clean all equipment with clean water immediately after use.
Keep container lip closed and in an upright position. Store in a cool shaded place.
Do you know the area?
Enter the height and the length of the surface you want to paint.
Great! Just add it below and find out how much you'll need.
Measure the height and length of the surface you want to paint (metres).
This is an estimate based on 2 coats. Actual coverage will depend on the conditions of the surface. If the colour change is strong, more coats may be required.Calculate again